flexiblefullpage
billboard
interstitial1
catfish1
Currently Reading

Updated standard for liquid applied flashing for exterior wall openings released

Codes and Standards

Updated standard for liquid applied flashing for exterior wall openings released

AAMA document establishes minimum performance requirements.


By Peter Fabris, Contributing Editor | June 27, 2019

Courtesy Pixabay

The American Architectural Manufacturers Association (AAMA) has released an updated specification establishing minimum performance requirements for liquid-applied flashing used to provide water-resistive seals around exterior wall openings in buildings.

The standard applies to fenestration products, such as windows and doors, as well as other through-wall penetrations. AAMA 714-19, “Voluntary Specification for Liquid Applied Flashing Used to Create a Water-Resistive Seal around Exterior Wall Openings in Buildings,” was last updated in 2015.

“Liquid-applied flashing products are seeing increasing application for sealing building interfaces, including flashing around windows and doors,” said Jim Katsaros (DuPont Building Performance Solutions), chair of the AAMA Flashing Committee, in an AAMA news release. “These products offer many performance advantages, including outstanding adhesion to a wide variety of substrates, ultimate conformability for complex geometries and, in many cases, vapor permeable water-resistant seals.”

The AAMA 714 document also sets minimum durability requirements for these materials. Both the International Residential Code and the International Building Code reference AAMA 714.

Related Stories

Codes and Standards | May 21, 2018

New standard tests quietness of floors

ASTM International method will help manufacturers test their flooring materials.

Codes and Standards | May 17, 2018

California will require solar panels on most new homes

Projected to add $10,000 to cost of new homes.

Codes and Standards | May 16, 2018

New resources offer tips on off-site construction

NIBS documents address using pre-cast concrete, and commercial and legal considerations of modular construction.

Codes and Standards | May 15, 2018

Blast testing of loaded mass timber structures yields positive results

Four tests covered a spectrum of blast loads.

Codes and Standards | May 14, 2018

Maryland makes general contractors liable for failure of subs to pay employees

GCs could have to pay for up to three times the wages owed.

Codes and Standards | May 10, 2018

Data collection, machine learning boost building efficiency

Sensors, software algorithms squeeze out waste.

Codes and Standards | May 9, 2018

OSHA and state safety agencies write more than 100 silica citations in 6 months

Actions tending to come with investigation of other site conditions.

Codes and Standards | May 8, 2018

Powerhouse coalition builds energy positive buildings

The goal: build buildings that provide more power than they cost to build, run, and demolish.

Codes and Standards | May 7, 2018

Plan advances in Los Angeles for Climate Emergency Mobilization Department

Would oversee efforts to reduce greenhouse gas emissions across the city.

Codes and Standards | May 3, 2018

Data collection, machine learning boost building efficiency

Sensors, software algorithms squeeze out waste.

boombox1
boombox2
native1

More In Category


Reconstruction & Renovation

Movement to protect historic buildings raises sharp criticism

While the movement to preserve historic buildings has widespread support, it also has some sharp critics with well-funded opposition groups springing up in recent years. Some opponents are linked to the Stand Together Foundation, founded and bankrolled by the Koch family’s conservative philanthropic organization, according to a column in Governing magazine.



halfpage1

Most Popular Content

  1. 2021 Giants 400 Report
  2. Top 150 Architecture Firms for 2019
  3. 13 projects that represent the future of affordable housing
  4. Sagrada Familia completion date pushed back due to coronavirus
  5. Top 160 Architecture Firms 2021