The Fenestration and Glazing Industry Alliance (FGIA) updated a specification establishing minimum performance requirements for self-adhering flashing surrounding common exterior fenestration products.
AAMA 711-20, Specification for Self-Adhering Flashing Used for Installation of Exterior Wall Fenestration Products, was created in 2007. This is the document’s second update. It was last updated in 2013.
“Self-adhered flashing products are broadly used at the window/wall interface to provide a durable moisture seal and enhance the long-term performance of the installation,” said Jim Katsaros (DuPont Performance Building Solutions), chair of the FGIA Flashing Committee, in a news release. “This document specifies essential material properties, such as adhesive bond strength to various building substrates, sealability through fastener penetrations, and weathering tests for UV and thermal exposure to help ensure the long-term performance of these products.”
The new AAMA 711 standard provides significant updates to select test methods, particularly regarding sealability through fasteners and new guidelines for minimum product width. AAMA 711 is referenced in both the IRC and IBC for the use of self-adhered flashing products around windows and doors.
Related Stories
| Oct 3, 2013
Florida contractors worry that regulations will hamper their ability to hire
Regulations such as the E-Verify rule and the Affordable Care Act could hinder contractors from hiring additional workers, according to some Florida contractors.
| Oct 3, 2013
Fall protection violations top OSHA citations list
Violations of fall-protection standards in fiscal 2013 are again the most frequent source of citations from the Occupational Safety and Health Administration, according to its top 10 list.
| Oct 3, 2013
Arizona utility pushes for change in building codes to boost efficiency on all commercial projects
Many large construction projects in Arizona are going green by paying attention to energy efficiency, but smaller buildings that are often rented out haven't yet jumped on the bandwagon.
| Oct 3, 2013
Bipartisan energy efficiency bill stalled; may not be revived this year
The Senate spent the first two weeks of September trying to pass bipartisan energy efficiency legislation, commonly known as Shaheen-Portman (S. 1392) that would have impacted building codes.
| Oct 3, 2013
LEED credential exams will feature LEED v4 material beginning next spring
The LEED Professional Credential exams for the LEED Green Associate and LEED AP with specialty designations will feature LEED v4 material beginning in late spring 2014.
| Sep 26, 2013
Ballot period on National CAD Standards open until Oct. 13
The Ballot Comment Period to update the nation’s leading computer-aided design (CAD) standard is now open.
| Sep 26, 2013
OSHA encourages comments on respirable crystalline silica rules
The Occupational Safety and Health Administration’s proposed rulemaking for respirable crystalline silica has been published in the Federal Register.
| Sep 26, 2013
EPA’s final rule on updated ASTM standard likely to be withdrawn
The Environmental Protection Agency is expected to withdraw a direct final ruleissued in Augustregarding an ASTM standard for Phase I Environmental Site.
| Sep 26, 2013
A primer on RoofPoint green-rating system for commercial roofs
The RoofPoint green-rating system can be used to construct more energy-efficient and sustainable commercial roofs.
| Sep 26, 2013
ConsensusDocs releases updated federal subcontract to help construction firms perform federal work
The newly revised ConsensusDocs standard subcontract (ConsensusDocs 752 for federal work) will make it easier for general contractors and subcontractors to perform federal work.