A new residence hall on the University of Arkansas campus will serve as a testbed for researchers to study Cross-Laminated Timber (CLT) panels.
Professors in the university’s Fay Jones School of Architecture and Design and the College of Engineering are collaborating to measure and analyze the moisture content of the panels used in the buildings. Adohi Hall is the nation’s first large-scale mass timber residence hall project, according to a university news release.
Construction on the residential areas of Adohi Hall was completed this summer. The hall consists of two five-story residential buildings connected by a third building that provides a common area. To monitor the effects of rain and humidity, sensors were placed in CLT panels in moisture-prone areas—bathrooms, kitchen and laundry areas, and near the exterior of the buildings.
The approximately 200,000 sf project with 708 beds was designed by Leers Weinzapfel Associates of Boston, Modus Studio of Fayetteville, Mackey Mitchell Architects of St. Louis and OLIN of Philadelphia. CLT panels were used in floors and ceilings. Columns and beams were made from glue-laminated pieces, which are bonded together with the wood grain of each layer running parallel rather than perpendicular, as CLT panels do.
Related Stories
| Jan 25, 2013
AISC 206-13 standard for structural steel erectors available for review
AISC 206-13, a quality management system standard for structural steel erectors, is now available for public review.
| Jan 25, 2013
Builders Hardware Manufacturers Assn. revises five ANSI hardware standards
The Builders Hardware Manufacturers Association (BHMA) has released five revisions to ANSI/BHMA standards recently been approved by ANSI (American National Standards Institute).
| Jan 16, 2013
Pentagon plans huge spending cuts, including construction funds, amid budget deadlock fears
Defense Secretary Leon Panetta has ordered cuts to military spending as a precaution in case the White House and Congress fail to agree to avert $52 billion in cuts to the Pentagon budget this year.
| Jan 16, 2013
GSA's Green Proving Ground program pushes energy efficiency
The General Services Administration, which manages a portfolio of almost 10,000 buildings, is using the Green Proving Ground program to test technological advances in energy efficiency.
| Jan 16, 2013
Standards that include reflective roofs must take into account local climate
Roofs painted white can reflect heat and reduce warm-weather energy use, but in cooler regions like Minneapolis or Chicago, the issue of energy-efficiency is less straightforward.
| Jan 16, 2013
New standard for geothermal heat pump systems piping to be included in 2015 International Mechanical Code
NSF International, an independent global organization that writes standards, and tests and certifies products, has published the first in a series of American National Standards for Ground-Source Geothermal Piping Systems – NSF/ANSI 358-1.
| Jan 16, 2013
ANSI passes new safety standards for reinforcing steel and post-tensioning
The ANSI A10 Accredited Standards Committee for Construction and Demolition Operations recently approved amendments to the ANSI A10.9 Concrete and Masonry Standard.
| Jan 8, 2013
Congress passes Drywall Safety Act
Congress recently passed the Drywall Safety Act; President Barack Obama is expected to sign it soon.
| Jan 8, 2013
Building-integrated PVs could help boost green standards over the next few years
A developing technology could begin to have an impact on sustainable standards over the next few years.
| Jan 8, 2013
Revamp of codes among nine low tech steps to raise community resiliency
Updating of local zoning and building codes is one of nine low-tech steps that can boost sustainability and storm resiliency, according to this article.
