flexiblefullpage
billboard
interstitial1
catfish1
Currently Reading

Researchers use U. of Arkansas buildings as testbed for CLT panels

Codes and Standards

Researchers use U. of Arkansas buildings as testbed for CLT panels

Investigation could influence future use of the materials.


By Peter Fabris, Contributing Editor | September 13, 2019

Courtesy Pixabay

A new residence hall on the University of Arkansas campus will serve as a testbed for researchers to study Cross-Laminated Timber (CLT) panels.

Professors in the university’s Fay Jones School of Architecture and Design and the College of Engineering are collaborating to measure and analyze the moisture content of the panels used in the buildings. Adohi Hall is the nation’s first large-scale mass timber residence hall project, according to a university news release.

Construction on the residential areas of Adohi Hall was completed this summer. The hall consists of two five-story residential buildings connected by a third building that provides a common area. To monitor the effects of rain and humidity, sensors were placed in CLT panels in moisture-prone areas—bathrooms, kitchen and laundry areas, and near the exterior of the buildings.

The approximately 200,000 sf project with 708 beds was designed by Leers Weinzapfel Associates of Boston, Modus Studio of Fayetteville, Mackey Mitchell Architects of St. Louis and OLIN of Philadelphia. CLT panels were used in floors and ceilings. Columns and beams were made from glue-laminated pieces, which are bonded together with the wood grain of each layer running parallel rather than perpendicular, as CLT panels do.

Related Stories

| Sep 18, 2013

New AISC design guide on structural stainless steel now available

For the first time in the U.S., design professionals now have an authoritative resource on structural stainless steel with AISC Steel Design Guide No. 27, Structural Stainless Steel.

| Sep 18, 2013

DBIA’s ‘Design-Build Done Right’ best practices project seeks industry input

The Design-Build Institute of America (DBIA) is seeking industry input on its project to create a design-build best practices document.

| Sep 11, 2013

USGBC Florida Chapter survey to help contractors adopt sustainable practices

Contractors in Florida could benefit from a data collection project by the state's chapter of the U.S. Green Building Council.

| Sep 11, 2013

Disability, vet hiring standards for contractors are goals, not quotas

Contractors that fall short of new federal hiring rules concerning veterans and disabled persons will not necessarily incur penalties, says Patricia Shiu, director of the Office of Federal Contract Compliance Programs.

| Sep 11, 2013

Sports stadium accidents suggest code updates may be necessary to prevent falls

Since 2000, at least three individuals have died as a result of falling from the upper decks of stadiums in the United States. In addition, eight non-fatal falls have occurred in stadiums and arenas over that time.

| Sep 11, 2013

White paper examines Joint Commission requirements for NFPA codes in healthcare

The healthcare industry has experienced great attention from The Joint Commission concerning fire and life safety issues.

| Sep 11, 2013

San Francisco expected to drop firefighter air tank refilling station rule for skyscrapers

San Francisco is poised to drop a requirement that skyscrapers have refill stations so firefighters can recharge their air tanks during a blaze. The city has required that new high-rises have the air refill systems for about ten years. 

| Sep 5, 2013

State legislatures continue to raise the bar on green school construction

Since the beginning of 2013, the USGBC has followed more than 125 bills across 34 states that seek to advance healthy, high-performing schools.

| Sep 5, 2013

Construction industry groups create coalition to respond to new OSHA silica rule

A group of 11 construction trade associations has created the Construction Industry Safety Coalition in response to the Occupational Safety and Health Administration’s (OSHA) proposed rule on silica for the construction industry.

| Sep 5, 2013

Red tape delays California county jail construction projects

California authorized $1.2 billion for jail construction in 2007, but not a single county in the state has completed a jail project since then.

boombox1
boombox2
native1

More In Category




halfpage1

Most Popular Content

  1. 2021 Giants 400 Report
  2. Top 150 Architecture Firms for 2019
  3. 13 projects that represent the future of affordable housing
  4. Sagrada Familia completion date pushed back due to coronavirus
  5. Top 160 Architecture Firms 2021