A new residence hall on the University of Arkansas campus will serve as a testbed for researchers to study Cross-Laminated Timber (CLT) panels.
Professors in the university’s Fay Jones School of Architecture and Design and the College of Engineering are collaborating to measure and analyze the moisture content of the panels used in the buildings. Adohi Hall is the nation’s first large-scale mass timber residence hall project, according to a university news release.
Construction on the residential areas of Adohi Hall was completed this summer. The hall consists of two five-story residential buildings connected by a third building that provides a common area. To monitor the effects of rain and humidity, sensors were placed in CLT panels in moisture-prone areas—bathrooms, kitchen and laundry areas, and near the exterior of the buildings.
The approximately 200,000 sf project with 708 beds was designed by Leers Weinzapfel Associates of Boston, Modus Studio of Fayetteville, Mackey Mitchell Architects of St. Louis and OLIN of Philadelphia. CLT panels were used in floors and ceilings. Columns and beams were made from glue-laminated pieces, which are bonded together with the wood grain of each layer running parallel rather than perpendicular, as CLT panels do.
Related Stories
Codes and Standards | May 16, 2018
New resources offer tips on off-site construction
NIBS documents address using pre-cast concrete, and commercial and legal considerations of modular construction.
Codes and Standards | May 15, 2018
Blast testing of loaded mass timber structures yields positive results
Four tests covered a spectrum of blast loads.
Codes and Standards | May 14, 2018
Maryland makes general contractors liable for failure of subs to pay employees
GCs could have to pay for up to three times the wages owed.
Codes and Standards | May 10, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 9, 2018
OSHA and state safety agencies write more than 100 silica citations in 6 months
Actions tending to come with investigation of other site conditions.
Codes and Standards | May 8, 2018
Powerhouse coalition builds energy positive buildings
The goal: build buildings that provide more power than they cost to build, run, and demolish.
Codes and Standards | May 7, 2018
Plan advances in Los Angeles for Climate Emergency Mobilization Department
Would oversee efforts to reduce greenhouse gas emissions across the city.
Codes and Standards | May 3, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 2, 2018
Energy Department releases Updated EnergyPlus and OpenStudio building energy modeling tools
The tools can now accept input in epJSON format.
Codes and Standards | May 1, 2018
ASHRAE publishes new energy simulation-aided design standard
Requires building energy modeling during schematic design.