New York City’s regulation that requires contractors to hire independent safety inspectors for job sites is holding up projects worth millions of dollars, contractors say. The problem: not enough inspectors to go around.
Architect Howard Zimmerman told the New York Post that the city’s construction industry is in a boom cycle and projects have been halted because of a shortage of inspectors. He said that his firm has 20 projects worth millions on hold until safety inspectors can be made available.
Some in the construction industry are asking the city to change the site inspector requirement. Inspectors must be on site to check safety equipment for all buildings over 15 stories tall. The dearth of qualified inspectors has gotten so bad that two construction firms were recently hit with criminal charges for hiring hairdressers and cooks to pose as licensed professionals.
One proposal is to undo code changes created in 2008 that added the safety inspector requirement to restoration projects. Previously they were only needed on new construction.
(http://nypost.com/2014/08/25/construction-industry-petitions-for-changes-in-safety-regulations/)
Related Stories
Codes and Standards | May 16, 2018
New resources offer tips on off-site construction
NIBS documents address using pre-cast concrete, and commercial and legal considerations of modular construction.
Codes and Standards | May 15, 2018
Blast testing of loaded mass timber structures yields positive results
Four tests covered a spectrum of blast loads.
Codes and Standards | May 14, 2018
Maryland makes general contractors liable for failure of subs to pay employees
GCs could have to pay for up to three times the wages owed.
Codes and Standards | May 10, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 9, 2018
OSHA and state safety agencies write more than 100 silica citations in 6 months
Actions tending to come with investigation of other site conditions.
Codes and Standards | May 8, 2018
Powerhouse coalition builds energy positive buildings
The goal: build buildings that provide more power than they cost to build, run, and demolish.
Codes and Standards | May 7, 2018
Plan advances in Los Angeles for Climate Emergency Mobilization Department
Would oversee efforts to reduce greenhouse gas emissions across the city.
Codes and Standards | May 3, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 2, 2018
Energy Department releases Updated EnergyPlus and OpenStudio building energy modeling tools
The tools can now accept input in epJSON format.
Codes and Standards | May 1, 2018
ASHRAE publishes new energy simulation-aided design standard
Requires building energy modeling during schematic design.
