flexiblefullpage
billboard
interstitial1
catfish1
Currently Reading

OSHA construction safety inspections fall 84% during COVID-19 pandemic

Codes and Standards

OSHA construction safety inspections fall 84% during COVID-19 pandemic

Agency focuses on preventing disease transmission in healthcare industry.


By Peter Fabris, Contributing Editor | June 8, 2020

Courtesy Pixabay

OSHA’s in-person checks of construction sites have plunged by 84% during the COVID-19 pandemic.

The agency has focused its attention on virus transmission hazards in the health-care industry, according to OSHA data. In the first week of March, OSHA conducted about 395 construction inspections. The number of inspections at construction sites dropped to about 65 during the week of April 26.

Construction work has continued across much of the nation, as the federal government deemed it an essential industry. Some 975,000 construction workers became unemployed in April, but there were still 6.6 million people employed in construction.

If a construction hazard is less than an imminent danger, and unless there is a fatality, the likelihood of an inspection now is low, according to a trade union executive.

Related Stories

| Jan 16, 2013

ANSI passes new safety standards for reinforcing steel and post-tensioning

The ANSI A10 Accredited Standards Committee for Construction and Demolition Operations recently approved amendments to the ANSI A10.9 Concrete and Masonry Standard.

| Jan 8, 2013

Congress passes Drywall Safety Act

Congress recently passed the Drywall Safety Act; President Barack Obama is expected to sign it soon.

| Jan 8, 2013

Building-integrated PVs could help boost green standards over the next few years

A developing technology could begin to have an impact on sustainable standards over the next few years.

| Jan 8, 2013

Revamp of codes among nine low tech steps to raise community resiliency

Updating of local zoning and building codes is one of nine low-tech steps that can boost sustainability and storm resiliency, according to this article.

| Jan 8, 2013

Group releases safety and building codes from 24 countries

Public.Resource.Org released 10,062 public safety documents including building codes covering 24 countries and 6 regions.

| Jan 8, 2013

Montana developing high-performance building standards for state projects

The Montana Department of Administration is developing a single building standard for all state facilities, and hopes to have a plan in place this spring.

| Jan 4, 2013

AGC economist says "fiscal cliff" deal will give construction a boost

The deal in Congress to avoid going over the so-called fiscal cliff "should encourage many businesses to go ahead with projects they have held in reserve," said Ken Simonson, chief economist of the Associated General Contractors of America.

| Jan 4, 2013

California standards on furnishings, insulation to be revised

California is revising the state’s standards on interior furniture and insulation to maintain or improve fire safety while reducing or eliminating the use of toxic chemicals.

| Jan 4, 2013

Tilt-Up Concrete Association releases new temporary wind bracing guidelines

The Tilt-Up Concrete Association has released revised guidelines on Temporary Wind Bracing of Tilt-Up Concrete Panels During Construction. 

| Jan 4, 2013

San Diego office tower to be America's biggest net-zero building

The 13-floor, 415,000 sf La Jolla Commons II office tower in San Diego will be the largest building in the U.S. built to the net-zero standard upon completion in 2014, according to real estate firm Hines.

boombox1
boombox2
native1

More In Category




halfpage1

Most Popular Content

  1. 2021 Giants 400 Report
  2. Top 150 Architecture Firms for 2019
  3. 13 projects that represent the future of affordable housing
  4. Sagrada Familia completion date pushed back due to coronavirus
  5. Top 160 Architecture Firms 2021