North Carolina officials will not rely on FEMA to identify high-risk flood zones.
Instead, the state will strive to compile its own data. Officials say FEMA maps have not been updated quickly enough based on recent experience. As proof, they say that more than 77% of homes damaged by Hurricane Matthew in 2016 were not located in federally designated flood zones.
When a home is rebuilt after suffering storm damage, state officials are going beyond a federal block grant program requirement that homes be elevated two feet above FEMA’s base flood elevation. They are using the high-water mark that inspectors find in the home as the point from which the home is raised two feet.
A 2017 report by the Department of Homeland Security’s Inspector General found that 58% of flood maps nationwide were either outdated or inaccurate. At least 22 states and hundreds of local communities already require new construction to be elevated higher than federal requirements, according to the Weather Channel.
Related Stories
Codes and Standards | May 15, 2018
Blast testing of loaded mass timber structures yields positive results
Four tests covered a spectrum of blast loads.
Codes and Standards | May 14, 2018
Maryland makes general contractors liable for failure of subs to pay employees
GCs could have to pay for up to three times the wages owed.
Codes and Standards | May 10, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 9, 2018
OSHA and state safety agencies write more than 100 silica citations in 6 months
Actions tending to come with investigation of other site conditions.
Codes and Standards | May 8, 2018
Powerhouse coalition builds energy positive buildings
The goal: build buildings that provide more power than they cost to build, run, and demolish.
Codes and Standards | May 7, 2018
Plan advances in Los Angeles for Climate Emergency Mobilization Department
Would oversee efforts to reduce greenhouse gas emissions across the city.
Codes and Standards | May 3, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 2, 2018
Energy Department releases Updated EnergyPlus and OpenStudio building energy modeling tools
The tools can now accept input in epJSON format.
Codes and Standards | May 1, 2018
ASHRAE publishes new energy simulation-aided design standard
Requires building energy modeling during schematic design.
Codes and Standards | Apr 30, 2018
CALGreen projects pre-approved for streamlined LEED v4 requirements
Reduces need to run additional energy models.