The American Institute of Architects has released a new standard contract form to accommodate architects’ facility support services.
AIA Document B210–2017 is meant to be added to owner-architect agreements where architects provide services including building certification assistance, maintenance management services, digital facility management system operation, and ongoing commissioning services. The new form can be used with AIA Document B102–2017, Standard Form of Agreement Between Owner and Architect, to provide the Architect’s sole scope of services.
It can also be used with B102–2017 in conjunction with other standard form services documents. The new form may also be incorporated into any owner-architect agreement when the agreement is used with G802–2017, Amendment to the Professional Services Agreement, to create a modification to any owner-architect agreement.
The new form provides a table that offers a broad listing of possible facility support services and can serve as a discussion guide for architects and owners to establish the final scope of services. Some of the services included in the scope of work go beyond traditional architectural services. The architect should thus consult with a professional liability insurance provider to find out if the non-traditional services are covered in the architect’s policy before beginning these services, AIA advises.
AIA contract documents may require modification to comply with state or local laws. Users should consult an attorney before completing or modifying a document, AIA says.
For more information, visit: www.aiacontracts.org.
Related Stories
| Jan 16, 2013
New standard for geothermal heat pump systems piping to be included in 2015 International Mechanical Code
NSF International, an independent global organization that writes standards, and tests and certifies products, has published the first in a series of American National Standards for Ground-Source Geothermal Piping Systems – NSF/ANSI 358-1.
| Jan 16, 2013
ANSI passes new safety standards for reinforcing steel and post-tensioning
The ANSI A10 Accredited Standards Committee for Construction and Demolition Operations recently approved amendments to the ANSI A10.9 Concrete and Masonry Standard.
| Jan 8, 2013
Congress passes Drywall Safety Act
Congress recently passed the Drywall Safety Act; President Barack Obama is expected to sign it soon.
| Jan 8, 2013
Building-integrated PVs could help boost green standards over the next few years
A developing technology could begin to have an impact on sustainable standards over the next few years.
| Jan 8, 2013
Revamp of codes among nine low tech steps to raise community resiliency
Updating of local zoning and building codes is one of nine low-tech steps that can boost sustainability and storm resiliency, according to this article.
| Jan 8, 2013
Group releases safety and building codes from 24 countries
Public.Resource.Org released 10,062 public safety documents including building codes covering 24 countries and 6 regions.
| Jan 8, 2013
Montana developing high-performance building standards for state projects
The Montana Department of Administration is developing a single building standard for all state facilities, and hopes to have a plan in place this spring.
| Jan 4, 2013
AGC economist says "fiscal cliff" deal will give construction a boost
The deal in Congress to avoid going over the so-called fiscal cliff "should encourage many businesses to go ahead with projects they have held in reserve," said Ken Simonson, chief economist of the Associated General Contractors of America.
| Jan 4, 2013
California standards on furnishings, insulation to be revised
California is revising the state’s standards on interior furniture and insulation to maintain or improve fire safety while reducing or eliminating the use of toxic chemicals.
| Jan 4, 2013
Tilt-Up Concrete Association releases new temporary wind bracing guidelines
The Tilt-Up Concrete Association has released revised guidelines on Temporary Wind Bracing of Tilt-Up Concrete Panels During Construction.