flexiblefullpage
billboard
interstitial1
catfish1
Currently Reading

Gypsum Association releases updates to wallboard repair standards

Gypsum Association releases updates to wallboard repair standards

Recommendations for repairing joint ridging and fastener pops featured


By BD+C Staff | July 31, 2014
Photo: Findoutwhy via Wikimedia Commons
Photo: Findoutwhy via Wikimedia Commons

The Gypsum Association released updates to both GA-221 Repair of Joint Ridging and GA-222 Repairing Screw or Nail Pops standards publications. Each set of recommendations clarifies best practices associated with common wallboard repairs.

Joint ridging, or beading, is a uniform, fine linear deformation that occurs at the joints of finished and decorated gypsum panel products. Compression at the edges or ends of the panels due to extreme fluctuations of temperature and humidity is the most common cause of ridging; however, misaligned framing can also contribute to the problem. The Gypsum Association recommends waiting until a new structure has experienced at least one complete heating/cooling cycle before making repairs.

Fastener popping occurs most commonly from lumber shrinkage due to initially high moisture content in newly constructed wood framing. Overly long fastener length contributes to the problem. While fastener popping that appears before or during finishing and decoration should be repaired immediately; popping that occurs a month or more into the heating season should wait for repair until the season’s end.

In the case of fastener popping, the secure reattachment of the gypsum panel product to the framing is essential. All new screws or nails should be of the proper length. Key to the repair methods outlined in both GA-221-14 and GA-222-14 is careful sanding and treatment with joint compound as well as observing recommended drying times prior to redecoration.

(https://www.gypsum.org/2014/07/just-released-updated-recommendations-for-gypsum-panel-product-repairs/)

Related Stories

Codes and Standards | Oct 6, 2021

Intl. Code Council publishes EV and building codes resource

Assists communities in setting policies for electric vehicle charging requirements.

Codes and Standards | Oct 5, 2021

Feds award $1 billion to renovate health centers

Funds will modernize existing infrastructure and cover other COVID-19-related capital needs.

Codes and Standards | Oct 4, 2021

Boston City Council approves mandate for major emissions cuts for large buildings

Applies to buildings 20,000 sf or larger—about 4% of city’s buildings.

Codes and Standards | Oct 4, 2021

HPD Collaborative and Green Seal to align standards

Will result in expanded options for manufacturers to enhance sustainability reporting and certifications.

Codes and Standards | Sep 30, 2021

U.S. has a deficit of 5 million homes

Builders unable to keep pace with demand.

Codes and Standards | Sep 29, 2021

Mass Timber group study will compare structural round timber to glulam products and steel

Will compare costs, capabilities, and carbon impacts of structural materials.

Codes and Standards | Sep 28, 2021

Massachusetts creates Commission on Clean Heat

First-of-its kind body to set targets for buildings to reduce emissions from heating fuels.

Codes and Standards | Sep 27, 2021

Commercial real estate industry faces SEC climate disclosure regulations

Risks associated with climate change would have to be revealed.

Codes and Standards | Sep 22, 2021

Group proposes Carbon Use Intensity metric for new buildings

Plan would track embedded carbon on projects.

boombox1
boombox2
native1

More In Category




halfpage1

Most Popular Content

  1. 2021 Giants 400 Report
  2. Top 150 Architecture Firms for 2019
  3. 13 projects that represent the future of affordable housing
  4. Sagrada Familia completion date pushed back due to coronavirus
  5. Top 160 Architecture Firms 2021