The Gypsum Association released updates to both GA-221 Repair of Joint Ridging and GA-222 Repairing Screw or Nail Pops standards publications. Each set of recommendations clarifies best practices associated with common wallboard repairs.
Joint ridging, or beading, is a uniform, fine linear deformation that occurs at the joints of finished and decorated gypsum panel products. Compression at the edges or ends of the panels due to extreme fluctuations of temperature and humidity is the most common cause of ridging; however, misaligned framing can also contribute to the problem. The Gypsum Association recommends waiting until a new structure has experienced at least one complete heating/cooling cycle before making repairs.
Fastener popping occurs most commonly from lumber shrinkage due to initially high moisture content in newly constructed wood framing. Overly long fastener length contributes to the problem. While fastener popping that appears before or during finishing and decoration should be repaired immediately; popping that occurs a month or more into the heating season should wait for repair until the season’s end.
In the case of fastener popping, the secure reattachment of the gypsum panel product to the framing is essential. All new screws or nails should be of the proper length. Key to the repair methods outlined in both GA-221-14 and GA-222-14 is careful sanding and treatment with joint compound as well as observing recommended drying times prior to redecoration.
Related Stories
Codes and Standards | Dec 15, 2016
OSHA releases safety recommendation guide for construction industry
It is said to be most helpful to small and mid-sized contractors.
Codes and Standards | Dec 14, 2016
Cities must invest $375 billion to avoid catastrophic global climate change
C40 Cities Climate Leadership Group advocates low carbon infrastructure.
Codes and Standards | Dec 14, 2016
Resilient construction techniques pay for themselves over lifetime of buildings
Spending $340,000 for resiliency would pay for itself over the lifetime of a $10 million structure.
Codes and Standards | Dec 12, 2016
Dept. of Energy launches program to advance zero energy school design
Six school districts and two states are among the first to mainstream zero energy schools.
Codes and Standards | Dec 9, 2016
California city’s plan for net zero building includes net zero water usage
Santa Monica city services building aims for highest level of sustainability.
Codes and Standards | Dec 8, 2016
WELL and BREEAM to align standards
The goal is to make it easier for projects pursuing both standards.
Codes and Standards | Dec 7, 2016
U.S. lumber industry pushes for import duties on Canadian softwood
The industry claims the product is being sold below fair market value.
Codes and Standards | Dec 5, 2016
International Construction Measurement Standards draft released
The goal is to improve consistency for calculating costs and reducing risk.
Codes and Standards | Dec 2, 2016
D.C. Council passes bill to reduce number of blighted properties
The new legislation reduces the amount of time a vacant property can qualify for a lower tax rate.
Codes and Standards | Dec 1, 2016
Passive House standard gaining influence in commercial sector
Some industry watchers predict it will become the base building code.