flexiblefullpage
billboard
interstitial1
catfish1
Currently Reading

Florida’s Surfside-inspired safety law puts pressure on condo associations

Codes and Standards

Florida’s Surfside-inspired safety law puts pressure on condo associations

Inspection requirement strains ability of engineers to provide services.


By Peter Fabris, Contributing Editor | October 27, 2022
Florida Surfside Condo Law
Courtesy Pexels.

A Florida law intended to prevent tragedies like the Surfside condominium collapse will place a huge financial burden on condo associations and strain architecture and engineering resources in the state.

The law requires that by the end of 2024 condominiums that are at least three stories tall and within 3 miles of the coast be inspected by a licensed engineer or architect when they are 25 years old and buildings more than 3 miles inland at 30 years old. The law will be financially burdensome for many associations, especially older ones.

Condo associations had been allowed to waive reserve funds for maintenance, but will now be required to have enough money in their reserves by 2025 to fund all repairs needed to maintain their buildings’ structural integrity. This work could easily run into the hundreds of thousands of dollars.

What’s more, thousands of condos will need to have inspections over a short period. It will be difficult, if not impossible, for architects and engineers to get to all that work done within the prescribed deadline.

The law applies to 1.5 million condos operated by nearly 28,000 associations. Some older properties in the most desirable coastal areas are expected to be targets for developers because owners will not be able to absorb the cost of capital assessments to make extensive repairs. Developers would demolish old properties and build new luxury properties on site.

Related Stories

| Jan 16, 2013

New standard for geothermal heat pump systems piping to be included in 2015 International Mechanical Code

NSF International, an independent global organization that writes standards, and tests and certifies products, has published the first in a series of American National Standards for Ground-Source Geothermal Piping Systems – NSF/ANSI 358-1.

| Jan 16, 2013

ANSI passes new safety standards for reinforcing steel and post-tensioning

The ANSI A10 Accredited Standards Committee for Construction and Demolition Operations recently approved amendments to the ANSI A10.9 Concrete and Masonry Standard.

| Jan 8, 2013

Congress passes Drywall Safety Act

Congress recently passed the Drywall Safety Act; President Barack Obama is expected to sign it soon.

| Jan 8, 2013

Building-integrated PVs could help boost green standards over the next few years

A developing technology could begin to have an impact on sustainable standards over the next few years.

| Jan 8, 2013

Revamp of codes among nine low tech steps to raise community resiliency

Updating of local zoning and building codes is one of nine low-tech steps that can boost sustainability and storm resiliency, according to this article.

| Jan 8, 2013

Group releases safety and building codes from 24 countries

Public.Resource.Org released 10,062 public safety documents including building codes covering 24 countries and 6 regions.

| Jan 8, 2013

Montana developing high-performance building standards for state projects

The Montana Department of Administration is developing a single building standard for all state facilities, and hopes to have a plan in place this spring.

| Jan 4, 2013

AGC economist says "fiscal cliff" deal will give construction a boost

The deal in Congress to avoid going over the so-called fiscal cliff "should encourage many businesses to go ahead with projects they have held in reserve," said Ken Simonson, chief economist of the Associated General Contractors of America.

| Jan 4, 2013

California standards on furnishings, insulation to be revised

California is revising the state’s standards on interior furniture and insulation to maintain or improve fire safety while reducing or eliminating the use of toxic chemicals.

| Jan 4, 2013

Tilt-Up Concrete Association releases new temporary wind bracing guidelines

The Tilt-Up Concrete Association has released revised guidelines on Temporary Wind Bracing of Tilt-Up Concrete Panels During Construction. 

boombox1
boombox2
native1

More In Category




Reconstruction & Renovation

Movement to protect historic buildings raises sharp criticism

While the movement to preserve historic buildings has widespread support, it also has some sharp critics with well-funded opposition groups springing up in recent years. Some opponents are linked to the Stand Together Foundation, founded and bankrolled by the Koch family’s conservative philanthropic organization, according to a column in Governing magazine.

halfpage1

Most Popular Content

  1. 2021 Giants 400 Report
  2. Top 150 Architecture Firms for 2019
  3. 13 projects that represent the future of affordable housing
  4. Sagrada Familia completion date pushed back due to coronavirus
  5. Top 160 Architecture Firms 2021