flexiblefullpage
billboard
interstitial1
catfish1
Currently Reading

Construction spending hits four-year peak after rare spike in public outlays

Construction spending hits four-year peak after rare spike in public outlays

Totals for the first 10 months of 2013 show a jump in residential construction, flat nonresidential work, and a drop in public categories.


By AGC | December 3, 2013

An unusual surge in public construction in October pushed total construction spending to its highest level since May 2009 despite a dip in both private residential and nonresidential activity, according to an analysis of new Census Bureau data by the Associated General Contractors of America. Association officials urged lawmakers in Washington to make water and surface transportation investment a top federal priority.

“Nearly every category of public construction increased in October, according to the preliminary Census figures, although for the first 10 months of 2013 combined, public spending continues to lag the 2012 year-to-date total,” said Ken Simonson, the association's chief economist. “Meanwhile, residential spending slipped for the month but still showed strong year-to-date gains, and nonresidential spending remained stuck in neutral.”

Construction put in place in October totaled $908 billion, 0.8 percent higher than in September. But figures for August and July were revised down below levels that initially exceeded the current October estimate. The total for the first 10 months of 2013 was 5.0 percent above the year-to-date mark for the same months in 2012.

Public construction spending jumped 3.9 percent for the month but trailed the 2012 year-to-date total by 2.8 percent. The two largest public components were mixed: highway and street construction increased 0.6 percent in October and 0.3 percent year-to-date, while educational construction leaped 8.5 percent for the month but fell 8.5 percent year-to-date, Simonson said.

Private residential spending slid 0.6 percent for the month but still climbed 17 percent year-to-date. New single-family construction decreased 0.6 percent in October but soared 30 percent in the first 10 months of 2013 compared with 2012. New multifamily spending advanced 2.2 percent in October and 46 percent year-to-date.

Private nonresidential spending edged down 0.5 percent for the month and up 0.8 percent year-to-date, Simonson observed. The largest private nonresidential category, power—including oil and gas as well as electricity—plunged 5.7 percent and 5.8 percent over the two time periods. But the next three niches in size—manufacturing, commercial (retail, warehouse and farm), and office—rose for the month and year-to-date.

“Construction will likely display varied patterns in the next several months,” Simonson said. “Multifamily construction will keep burgeoning but single-family homebuilding may stall. Private nonresidential spending should benefit from more power, energy and manufacturing work. Public construction remains threatened.”

Association officials said Congress and the administration should keep public construction from returning to its recent slump by quickly completing Water Resources Development legislation that has already passed both houses and passing a new surface transportation bill next year that funds repairs to deteriorating highway, bridge and transit infrastructure.  They added that any new transportation bill must include provisions to adequately fund the nearly depleted federal Highway Trust Fund.

“If Congress can act in a bipartisan way on transportation funding as it did on the Water Resources bill, it can avoid a cliff-like drop in highway spending,” said Stephen E. Sandherr, the association’s chief executive officer.

Related Stories

| Feb 27, 2014

Open or private offices? It depends on the business plan

Open layouts are grabbing headlines as a hallmark of the new workplace—think the Google campus or Facebook's headquarters. And for smaller-scale operations, open designs are often lauded for being less expensive than private office plans. But does that mean all offices should have an open layout?

| Feb 27, 2014

3 reasons to apply computational fluid dynamics on your next project

From right-sizing mechanical systems to understanding the impact of design alternatives, CFD offers a host of benefits for the Building Team. 

| Feb 27, 2014

12 facts about heat-treated glass: Why stronger isn’t always better

Glass is heat-treated for two reasons: the first is to increase its strength to resist external stresses such as wind and snow loads, or thermal loads caused by the sun’s energy. The second is to temper glass so that it meets safety glazing requirements defined by applicable codes or federal standards. 

| Feb 27, 2014

Metal Construction Association introduces two Environmental Product Declarations

Two Environmental Product Declarations (EPD), one for Metal Composite Material Panels and one for  Roll Formed Steel Panels for Roofs and Walls, are now available free of charge from the Metal Construction Association (MCA) on its website.

| Feb 27, 2014

Bluebeam Software launches Revu 12 for better field-ready document management and project collaboration

The latest version of the company’s flagship solution better enables users in document-intensive industries to digitally collaborate on project documents and more easily connect the office to the field.

| Feb 27, 2014

PocketCake lunches CPU designed for virtual reality simulations

The company's Virtual Reality Simulation Converter Assembly is three times more powerful than the average high-performance computer and allows for up to eight people to experience a virtual reality simulation at the same time.

| Feb 26, 2014

Adaptive reuse project brings school into historic paper mill

The project features nontraditional classrooms for collaborative learning, an arts and music wing, and a technologically sophisticated global resource center.

| Feb 26, 2014

Use this app to streamline safety inspections

Using the iAuditor app, one of our Skanska teams developed electronic reports that make safety inspections more efficient, and that make it easier to address any issues emerging from them.

| Feb 26, 2014

Startup PocketCake aims to bring virtual reality simulations to the AEC masses

Founded in 2012, the development firm offers custom virtual reality simulations for the price of a typical architectural illustration.

| Feb 26, 2014

Billie Jean King National Tennis Center serving up three-phase expansion

The project includes the construction of two new stadiums and a retractable roof over the existing Arthur Ashe Stadium. 

boombox1
boombox2
native1

More In Category

Great Solutions

41 Great Solutions for architects, engineers, and contractors

AI ChatBots, ambient computing, floating MRIs, low-carbon cement, sunshine on demand, next-generation top-down construction. These and 35 other innovations make up our 2024 Great Solutions Report, which highlights fresh ideas and innovations from leading architecture, engineering, and construction firms.




halfpage1

Most Popular Content

  1. 2021 Giants 400 Report
  2. Top 150 Architecture Firms for 2019
  3. 13 projects that represent the future of affordable housing
  4. Sagrada Familia completion date pushed back due to coronavirus
  5. Top 160 Architecture Firms 2021