After stalled projects and uncertainties due to COVID plagued the construction industry in 2020, commercial and multifamily construction starts bounced back in 2021, according to Dodge Construction Network.
Commercial and multifamily construction starts increased 16% nationwide in 2021. But starts remain below 2019 levels, indicating that the sector has not fully recovered from the impact of the pandemic.
In the top 20 metro areas, commercial and multifamily starts were 5% below the level recorded in 2019, and national commercial and multifamily starts were just 2% below the 2019 level. Larger metro regions have lagged other areas as demand for construction shifted away from denser urban zones.
In the top 10 metro areas, commercial and multifamily starts were 9% below their 2019 levels, while starts in the metro areas ranked 11-20 were up 5% from 2019. This shows that in 2021, smaller, less dense metropolitan areas became increasingly popular.
Related Stories
Codes and Standards | May 14, 2018
Maryland makes general contractors liable for failure of subs to pay employees
GCs could have to pay for up to three times the wages owed.
Codes and Standards | May 10, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 9, 2018
OSHA and state safety agencies write more than 100 silica citations in 6 months
Actions tending to come with investigation of other site conditions.
Codes and Standards | May 8, 2018
Powerhouse coalition builds energy positive buildings
The goal: build buildings that provide more power than they cost to build, run, and demolish.
Codes and Standards | May 7, 2018
Plan advances in Los Angeles for Climate Emergency Mobilization Department
Would oversee efforts to reduce greenhouse gas emissions across the city.
Codes and Standards | May 3, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 2, 2018
Energy Department releases Updated EnergyPlus and OpenStudio building energy modeling tools
The tools can now accept input in epJSON format.
Codes and Standards | May 1, 2018
ASHRAE publishes new energy simulation-aided design standard
Requires building energy modeling during schematic design.
Codes and Standards | Apr 30, 2018
CALGreen projects pre-approved for streamlined LEED v4 requirements
Reduces need to run additional energy models.
Codes and Standards | Apr 26, 2018
New standard supports community resilience
ASTM International guidance supports cost-effective ways to withstand and recover from disasters.