flexiblefullpage
billboard
interstitial1
catfish1
Currently Reading

Code-conforming wood design guide available

Codes and Standards

Code-conforming wood design guide available

The guide summarizes provisions for the use of wood and wood products in the 2018 IBC.


By Peter Fabris, Contributing Editor | August 29, 2019
Code-conforming wood design guide available

Photo: Tall wood building student residence currently under construction at UBC in Vancouver, B.C. Credit: Acton Ostry Architects

  

The 2018 Code Conforming Wood Design (CCWD), a joint publication of the American Wood Council (AWC) and the International Code Council, is now available.

The free download summarizes key provisions related to the use of wood and wood products as they appear in the 2018 International Building Code (IBC). The publication compiles the occupancy and height and area provisions of the IBC for wood structures into one publication.

“The complexity and scope of the IBC makes it difficult for designers to know about all of the code provisions that affect the use of wood products in construction,” said Kenneth Bland, AWC vice president of codes & regulations, in a news release. “CCWD consolidates and provides additional explanation for many of those provisions to make wood building compliance with the IBC as simple as possible.”

Among the 2018 IBC code changes mentioned in the 2018 CCWD:
· Alternatives for protecting attics in buildings using an NFPA 13R automatic sprinkler system. This has specific application to construction designed in accordance with IBC Sections 510.2 and 510.4, based on the height of the roof above the lowest level of required fire department vehicle access.
· Provisions for a fire-watch during non-working hours when construction exceeds 40 feet in height above the lowest adjacent grade, if required by the fire code official. The International Fire Code contains additional fire watch provisions.
· Updated references to AWC’s 2018 National Design Specification for Wood Construction and 2018 Wood Frame Construction Manual.

Related Stories

| Jan 18, 2012

California approves open cell spray foam for energy efficiency standards

The California Energy Commission (CEC) now recognizes open-cell spray foam as an accepted insulation in its 2008 Building Energy Efficiency Standards.

| Jan 5, 2012

Building to LEED standards now an 'easy call' from cost standpoint

Once seen as a cost burden, building to LEED standards is now an "easy call," according to Dan Probst, chairman of energy and sustainability for real estate management and development firm Jones Lang LaSalle.

| Jan 5, 2012

Minnesota's GreenStep Cities program aids communities in winning grants

GreenStep Cities, a Minnesota initiative, was designed to provide greater recognition to the state's communities for achievements in meeting sustainability standards and goals.

| Jan 5, 2012

Some ADA accessibility rules change in 2012

Some changes to the Americans with Disabilities Act go into effect beginning March 15, 2012.

| Jan 5, 2012

Ontario's stringent energy code has builders concerned over indoor air quality

Some Ontario builders are worried that new building code requirements with stricter energy efficiency measures could lead to poor indoor air quality.

| Jan 5, 2012

New law bars Defense Department from new LEED certifications

The Defense Department will not be allowed to use any money to certify its buildings LEED Gold or Platinum, under a law President Obama signed Dec. 31.

| Jan 5, 2012

Some ADA accessibility rules change in 2012

Some changes to the Americans with Disabilities Act go into effect beginning March 15, 2012.

| Jan 3, 2012

New SJI Rule on Steel Joists

A new rule from the Steel Joist Institute clarifies when local reinforcement of joists is required for chord loads away from panel points. SJI members offer guidance about how and when to specify loads.

| Dec 29, 2011

OSHA enforcing new fall hazard standards

OSHA is enforcing its new fall protection standards, as evidenced by a recent crackdown in New York.

| Dec 29, 2011

NRCA offers program on new fall-protection requirements

The National Roofing Contractors Association's (NRCA's) program "Roofing Industry Fall Protection from A to Z" will be held Feb. 21 during the organization's 125th Annual Convention.

boombox1
boombox2
native1

More In Category




halfpage1

Most Popular Content

  1. 2021 Giants 400 Report
  2. Top 150 Architecture Firms for 2019
  3. 13 projects that represent the future of affordable housing
  4. Sagrada Familia completion date pushed back due to coronavirus
  5. Top 160 Architecture Firms 2021