The City of Guelph, Ontario, charged itself for failing to obtain a building permit before starting change room renovations at a community center.
The city will pay the Province of Ontario a $1,125 fine for the infraction. Earlier this year, the city completed renovations on a change room at the West End Community Centre. Later, staff realized a building permit had been applied for, but had not been obtained.
So, the city closed the change room. It was reopened after a full final inspection was completed by the building services department. The deputy chief administrative officer for infrastructure, development and enterprise, said the city has to hold itself to the same rigorous standards as other building owners.
The city has taken disciplinary action against the employees determined to be responsible for the mistake. Guelph officials said this is the first fine the city has had to pay for non-compliance with the Ontario Building Code.
Related Stories
Codes and Standards | May 15, 2018
Blast testing of loaded mass timber structures yields positive results
Four tests covered a spectrum of blast loads.
Codes and Standards | May 14, 2018
Maryland makes general contractors liable for failure of subs to pay employees
GCs could have to pay for up to three times the wages owed.
Codes and Standards | May 10, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 9, 2018
OSHA and state safety agencies write more than 100 silica citations in 6 months
Actions tending to come with investigation of other site conditions.
Codes and Standards | May 8, 2018
Powerhouse coalition builds energy positive buildings
The goal: build buildings that provide more power than they cost to build, run, and demolish.
Codes and Standards | May 7, 2018
Plan advances in Los Angeles for Climate Emergency Mobilization Department
Would oversee efforts to reduce greenhouse gas emissions across the city.
Codes and Standards | May 3, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 2, 2018
Energy Department releases Updated EnergyPlus and OpenStudio building energy modeling tools
The tools can now accept input in epJSON format.
Codes and Standards | May 1, 2018
ASHRAE publishes new energy simulation-aided design standard
Requires building energy modeling during schematic design.
Codes and Standards | Apr 30, 2018
CALGreen projects pre-approved for streamlined LEED v4 requirements
Reduces need to run additional energy models.