California reinstituted an ambitious plan to study dangerous earthquake faults and create zoning maps that could restrict development. In July, the California Geological Survey began to zone the Santa Monica fault, which is among 2,000 miles of fault lines statewide that still need to be mapped.
California drastically reduced these mapping efforts over the past 20 years because of budget cuts. Gov. Jerry Brown recently signed off on $1.49 million in new funding and $1.3 million in annual dedicated funding to be paid for with increased building permit fees.
Without the maps, many communities have limited information on the location of faults, and whether they might impact new development. More than a dozen properties were approved for construction on or near the Hollywood and Santa Monica faults over the last decade without in-depth studies that would have been required had the state zoned those faults, according to the Los Angeles Times. Both faults could cause major temblors.
Building permit fees were increased by about 30% to fund the mapping project.
(http://www.latimes.com/local/la-me-quake-faults-20140702-story.html)
Related Stories
Codes and Standards | May 16, 2018
New resources offer tips on off-site construction
NIBS documents address using pre-cast concrete, and commercial and legal considerations of modular construction.
Codes and Standards | May 15, 2018
Blast testing of loaded mass timber structures yields positive results
Four tests covered a spectrum of blast loads.
Codes and Standards | May 14, 2018
Maryland makes general contractors liable for failure of subs to pay employees
GCs could have to pay for up to three times the wages owed.
Codes and Standards | May 10, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 9, 2018
OSHA and state safety agencies write more than 100 silica citations in 6 months
Actions tending to come with investigation of other site conditions.
Codes and Standards | May 8, 2018
Powerhouse coalition builds energy positive buildings
The goal: build buildings that provide more power than they cost to build, run, and demolish.
Codes and Standards | May 7, 2018
Plan advances in Los Angeles for Climate Emergency Mobilization Department
Would oversee efforts to reduce greenhouse gas emissions across the city.
Codes and Standards | May 3, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 2, 2018
Energy Department releases Updated EnergyPlus and OpenStudio building energy modeling tools
The tools can now accept input in epJSON format.
Codes and Standards | May 1, 2018
ASHRAE publishes new energy simulation-aided design standard
Requires building energy modeling during schematic design.
