A California state senator has introduced a bill that would require the installation of solar power on new commercial and residential buildings statewide.
If the proposal were to become law, it would be the first such requirement in U.S. history, according to a press release by Scott Wiener, the legislator behind the bill. The statewide mandate would be similar to a city law that Wiener wrote and helped pass in 2016 as a member of the San Francisco Board of Supervisors.
The board approved the city ordinance last year that required new small and midsized buildings in San Francisco to include solar. Some other California cities have enacted similar solar mandates.
According to current California state law, all new residential and commercial buildings up to 10 stories tall must have 15% of their roof area solar ready—defined as unshaded and free of obtrusions. The proposed new legislation would require that solar be installed on the 15% of solar-ready roof area. The solar mandate could be fulfilled by either photovoltaic or solar water systems.
Related Stories
Codes and Standards | May 15, 2018
Blast testing of loaded mass timber structures yields positive results
Four tests covered a spectrum of blast loads.
Codes and Standards | May 14, 2018
Maryland makes general contractors liable for failure of subs to pay employees
GCs could have to pay for up to three times the wages owed.
Codes and Standards | May 10, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 9, 2018
OSHA and state safety agencies write more than 100 silica citations in 6 months
Actions tending to come with investigation of other site conditions.
Codes and Standards | May 8, 2018
Powerhouse coalition builds energy positive buildings
The goal: build buildings that provide more power than they cost to build, run, and demolish.
Codes and Standards | May 7, 2018
Plan advances in Los Angeles for Climate Emergency Mobilization Department
Would oversee efforts to reduce greenhouse gas emissions across the city.
Codes and Standards | May 3, 2018
Data collection, machine learning boost building efficiency
Sensors, software algorithms squeeze out waste.
Codes and Standards | May 2, 2018
Energy Department releases Updated EnergyPlus and OpenStudio building energy modeling tools
The tools can now accept input in epJSON format.
Codes and Standards | May 1, 2018
ASHRAE publishes new energy simulation-aided design standard
Requires building energy modeling during schematic design.
Codes and Standards | Apr 30, 2018
CALGreen projects pre-approved for streamlined LEED v4 requirements
Reduces need to run additional energy models.