The American Architectural Manufacturers Association (AAMA) has released an updated document specifying test methods, specifications, and field checks used to evaluate the structural adequacy of wall systems and their ability to resist water penetration and air leakage. Other optional tests are also included.
AAMA 501-15 is intended to be referenced in laboratory and field testing methods for exterior wall systems composed of curtain walls, storefronts, and sloped glazing. It was previously updated in 2005.
According to José Colon (Architectural Testing), Chair of the AAMA 501 Update Task Group, the standard was recently updated to make sure all labs and product manufacturers are on the same page with procedures and with pass/fail criteria for certain parts of the standard. These document updates also take into consideration new technologies for equipment being used for testing.
“Historically, AAMA 501 has been the base standard for project specific test requirements,” says Colon. “More and more specifications are being written that are even longer than what is called out in AAMA 501.” This is especially the case in places with more detailed codes, like Miami-Dade County or the state of Florida in general, said Colon.
Related Stories
| May 17, 2012
New standard for Structural Insulated Panels under development
ASTM International and NTA, Inc. are developing a new standard for Structural Insulated Panels (SIPs) that would create a path for U.S. manufacturers to meet the requirements of the Canadian building code.
| May 17, 2012
Webinar: ‘What Energy Codes and Standards Are Adopted Where and by Whom’
A June 12 webinar by the Construction Specifications Institute will outline what energy codes and standards have been adopted in each of the states for commercial buildings, and what is anticipated to be adopted in the future.
| May 17, 2012
California Governor orders new green standards on state buildings
California Gov. Jerry Brown issued an executive order recently that calls for all new or renovated state buildings of more than 10,000 sf to achieve LEED Silver or higher and incorporate clean, onsite power generation.
| May 17, 2012
New Zealand stadium roof collapse blamed on snow, construction defects
Heavy snowfall, construction defects, and design problems contributed to the collapse of the Stadium Southland roof in New Zealand in September 2010, a report has found.
| May 17, 2012
OSHA launches fall prevention campaign
The Occupational Safety and Health Administration (OSHA) recently launched an educational campaign to prevent deadly falls in the construction industry.
| May 15, 2012
Suffolk selected for Rosenwald Elementary modernization project
The 314-student station elementary school will undergo extensive modernization.
| May 10, 2012
Chapter 6 Energy Codes + Reconstructed Buildings: 2012 and Beyond
Our experts analyze the next generation of energy and green building codes and how they impact reconstruction.
| May 10, 2012
Resilience should be considered a sustainability factor
Since a sustainable building is one you don't have to rebuild, some building sustainability experts believe adding points for "resilience" to storms and earthquakes to the LEED sustainability rating tool makes sense.
